Bag filter installation steps

- Jan 13, 2020-

Bag filter installation steps


1 flow direction: different from the filter element, the correct flow direction of the filter bag is from inside to outside, that is, the filtered liquid enters the filter bag and passes through the filter material, and the filtered liquid flows out of the filter bag to the next step. The reverse flow will immediately lead to the operation failure.


Net support: bag filter must be supported by metal net support. The filter bag cannot bear system pressure alone. If there are no nets or the nets are installed incorrectly, the filter bag will break when pressure is applied. Make sure the basket is properly installed before installing the filter bag.


3 filter top seal: SDS seal ring can effectively prevent liquid leak detection. Traditional seal ring can also be used as a substitute, but the sealing effect is not flattering. The top of the filter is not properly sealed to prevent leakage, which will lead to filtration failure. Make sure the sealing ring is in close contact with the edge of the filter properly, otherwise side leakage may occur during the filtration process.

www.tr-filter.com