Frame diameter and surface waterproof treatment of filter cylinder

- Jul 15, 2019-

Frame diameter and surface waterproof treatment of filter cylinder


In the process of designing the filter cylinder, the outer diameter of the filter cylinder should be larger than the inner diameter of the filter cylinder by more than 10mm to some extent. This is mainly because the high and narrow space allows pollution particles to settle slowly in the outer layer of the filter cylinder to some extent, so that the filter cylinder can receive pollution blockage uniformly from the top down.


When determining the diameter and size of the inner skeleton of the filter cylinder, it is mainly to consider the size of the oil hole, which should not affect the filtration gas volume, and the influence of the size of the hole on the strength of the skeleton should be taken into account. The total strength of the inner skeleton is very important. First of all, the pressure difference borne by the filter cylinder should be supported by the skeleton, so the smaller the diameter, the higher the strength.


The filter cylinder needs to have sufficient margin of pressure difference limit. When calculating the product needed for filtration during operation, the area should be doubled. This is due to the fact that dust pollutants are unpredictable in practice.


Generally speaking, there are two kinds of filter materials in the filter cylinder, one is the synthetic fiber filter material, the other is the paper filter material. During the operation, the synthetic fiber nonwoven filter material can be divided into continuous fiber spunbonded polyester hot pressing and short fiber spunbonded polyester hot pressing according to its process.


Cartridge filter material in the working condition of the surface of the waterproof processing, the waterproofing treatment after the filter material of the infiltration Angle should be greater than 90 °, touch water level is not lower than Ⅳ level. Filter material oil treatment condition, filter material to do oil treatment. Polyester nonwoven filter material can withstand the working temperature of not less than 120℃. For other special working conditions such as high temperature and humidity, the material structure of filter cylinder should meet the application requirements.

www.tr-filter.com